Posiform Anti-Snoring Belt

Technical specifications

• Composition: top-of-the-range hypoallergenic breathable fabric
• Intelligent sensor with adjustable vibrations (7 intensity levels)
• Powered by 2 AAA alkaline batteries, operating time 2 to 6 months
• Adjustable size for girths from 70 to 125 cm
• Lightweight (26g without batteries), discreet, washable belt
• Class I medical device in compliance with European Directive MDR 2017/745

Indications

• Allows positional treatment of snoring/apnoea linked to a dorsal position during sleep.
• The device signals a back position that encourages snoring/apnoea with a vibration, prompting you to move to the side or prone position.

Contraindications

• It is strictly forbidden to use this device if you have a pacemaker.

Instructions for use

- Installing the belt :

• Remove the battery cover by pulling on the red tab.
• Insert the case into your belt pocket.
• Adjust the belt around your chest, applying slight tension.

- Switching on the appliance :

Press the central button on the device for a brief moment (less than a second). Two short vibrations tell you that the system is working. You can now lie down comfortably on your side or on your stomach. If you place yourself on your back after about 10 to 15 seconds, the system will vibrate intermittently until you return to a lateral or prone position.

- Stopping the anti-snoring device :

Press the appliance button for 2 to 3 seconds. A long vibration confirms the stop.

- Adjusting the vibration intensity :

When the appliance is switched off, press and hold the central button for more than 5 seconds. The appliance will produce vibrations of varying intensity. When you are satisfied with the vibration intensity, release the button. The appliance has now memorised your intensity level. It remains switched off and is ready to be reactivated.

- Replacing the batteries : 

1- Unscrew* the two screws at the back of the case. Remove the back of the case.

2- Remove the old batteries and press the button a few times. Insert two new 1.5V AAA batteries.

3- When the batteries are inserted, the system vibrates and the GREEN LED (new batteries) lights up for about 1 second*. The vibration intensity setting returns to the maximum default value.

4- Close the case, observing the direction without forcing it. If necessary, turn it half a turn and tighten** the two screws. Replace the case in the belt pocket.

* Note: use only a Philips PH1 screwdriver.

** Note: if the system does not respond when the batteries are inserted, please check the polarity of the batteries. If the problem persists, please check that the batteries inserted are new and charged.

Cleaning and maintenance of the appliance :

Clean the case with a slightly damp cloth. Do not rinse under water. The fabric belt can be hand-washed according to its labelling.

Warranty conditions :

The appliance is guaranteed for 2 years if the safety instructions are followed. Batteries and any damage they may cause are not guaranteed.

Disposal at the end of the product's life :

At the end of the appliance's life, please contact your local authority or distributor for waste disposal.